Joker – Thin CA Glue 20g – Red

Liquid cyanoacrylate adhesive glue “Joker” with thin viscosity – within just a few seconds glues metals, glass, wood, rubbers, plastics (small areas), ceramic surfaces, EPP and other materials. Indispensable for typical model-making works with wood, where it quickly creates a strong, tight and durable binder.

Packed in a round, airtight bottle with an applicator – glue content: 20g.

The thin consistency of cyanoacrylate adhesive makes it easy to apply in harder-to-reach places, penetrating porous surfaces or effectively filling gaps. The volatile and very liquid form of the glue means that it can “run away” from the glued surface if it is smooth and non-absorbent, so it should be used on porous materials or allowing the glue to soak into its structure. Application is strongly recommended when the glued surface is levelled horizontally. The thin consistency adhesive is also one of the fastest adhesive (and also the fastest drying) binders on the market – most materials will be permanently glued in just 2-5 seconds.

To cure and bond the glued surfaces immediately, we recommend to use this glue together with an activator (accelerator) “Joker” (available in 200ml spray cans), where after application at the gluing site, it will cure the binder and finish the gluing process.

Safety precautions – CA adhesive bonds instantly human skin (and eyes), is highly toxic, and its vapors are harmful to nasal mucosa. The adhesive should not be used by minors and juvenile modellers, unless under the strict supervision and care of an adult.

In case of accidental bonding, you may use the special debonder (also available in our shop) that can quickly and effectively neutralize the adhesive.

The durability of the CA glue depends on the storage temperature. After opening, it is reccomended to keep the glue in the refrigerator or other cool place, not exposed to sunlight or other sources of light or heat.

Shelf life depending on storage temperature:

+ 20 degrees C. – 6 months

+ 5 degrees C. – 12 months

(this no longer applies to glued surfaces)

Note: CA glue, regardless of its density, is not recommended for gluing paper, foamed polystyrene, depron, lightweight polystyrene foam, delicate fibers (and other textile materials), as well as for use in precision plastic modeling, due to the possibility of melting, unwanted hardening or for very delicate surfaces – deformation of the glued surface.